Talon F7 Fusion 20X20 Flight Controller

₹3,091.06

* Price is inclusive of 18% GST

Availability: Out of stock

Out of stock

SKU

OJ03458

Notify me when this product is in stock

Details

Helination's Flagship Flight Controller is here and WOW! Using a dual gyro setup in 90° phase and a F7 processor will have your quad dialed in to the max!
For Betaflight 4.2 or later, youll need to enter this into CLI set pinio_box = 40

Specs

MCU: STM32F722RET6 216MHz
2x ICM20602 GYROS 90 deg phase
Built in Betaflight OSD
Up to 8S (36V) direct battery power
Buzzer pads for external buzzer
Built in voltage monitoring resistor
5V 2A BEC
Dedicated LDO for Gyro, noise free gyro power
Dedicated LDO for OSD, cleaner OSD signal
Led strip shares 5V with 5V/2A BEC
6 UARTS: UART1, UART2, UART3, UART4, UART5, UART6
Built in camera control pin with resistor and capacitor
5 Full UARTS with RX AND TX pins
Logical pin layout for cleanest build possible
8 pin 4 IN 1 ESC plug
Remapable LED pad for additional motor output
TX3, RX3 can be used for I2C for external compass
5V, VBAT selectable VTX and CAM power
16M Blackbox flash chip
No flicker VTX pit mode switch (positive switch)
M4 Can be selected either led_strip signal or M4 signal for RPM filtering

20 X 20 mounting hole with true 25mm board dimensions
Official Betaflight Target: TalonF7Fusion
For the Legacy Clracingf7 target you will need to do the following:Resource MOTOR 6 NoneSaveTo get 5V to your VTX please go to the mode tab in Betaflight and setup a mode switch for vtx_pit
TOP LAYOUTBOTTOM LAYOUT

Setting up Pit Mode:
Resource MOTOR 4 C08
To get Motor 4 to work please use the CLI command below using Betaflight V4.0.4. A custom hex is coming soon for 4.0.4.
Please use user1 for Pit Switch Mode Switch
Save
resource pinio 1 A14,

More Information

More Information
Brand	CLRACING