Talon F7 V2 MPU6000 20X20 Flight Controller

Be the first to review this product

₹2,925.46

* Price is inclusive of 18% GST

Availability: Out of stock

Out of stock

SKU

OJ03459

Notify me when this product is in stock

Details

For Betaflight 4.2 or later, youll need to enter this into CLI set pinio_box = 40
1. MCU: STM32F722RET6 216MH
2. Proven noise free MPU6000
3. Buily in Betaflight OSD
4. Up to 8S (36V) direct battery power
5. Buzzer pads for external buzzer
6. Built in voltage monitoring resistor
7. 5V 2A BEC
8. Dedicated LDO for Gyro, noise free gyro power
9. Dedicated LDO for OSD, cleaner OSD signal
10. Led strip shares 5V with 5V/2A BEC
11. 6 UARTS: UART1, UART2, UART3, UART4, UART5, UART6
12. Built in camera control pin with resistor and capacitor
13. 5 Full UARTS with RX AND TX pins
14. Logical pin layout for cleanest build possible
15. 8 pin 4 IN 1 ESC plug
16. Remapable LED pad for additional motor output
17. TX3,RX3 can be used for I2C for external compass
18. 5V, VBAT selectable VTX and CAM power
19. 16M Blackbox flash chip
20. No flicker VTX pit mode switch (positive switch)
21. M4 Can be selected either led_strip signal or M4 signal for RPM filtering
20 X 20 mounting hole with true 25mm board dimensions
Please use user1 for Pit Switch Mode Switch
For the Legacy Clracingf7 target you will need to do the following:
Resource MOTOR 6 NoneSaveFor latest BF updates use these CLI commands for PitSwitch

Setting up Pit Mode:

TOP LAYOUTBOTTOM LAYOUT
To get 5V to your VTX please go to the mode tab in Betaflight and setup a mode switch for vtx_pit
Resource pinio 1 A14 Set pinio_box = 40 Save
Resource MOTOR 4 C08
To get Motor 4 to work please use the CLI command below using Betaflight V4.0.4. A custom hex is coming soon for 3.5.7 and 4.0.4.
Official Betaflight Target: TalonF7V2
Save
resource pinio 1 A14,

More Information

More Information
Brand	CLRACING

Reviews

Write Your Own Review

Only registered users can write reviews. Please Sign in or create an account