MATEKYS GPS M8Q-CAN

Specifications

• ArduPilot AP_Periph F303 CAN node
• GPS SAM-M8Q (GPS, GLONASS, Galileo)
• Magnetic Compass QMC5883L
• Barometer DPS310

• UART1, Firmware update
• UART2, onboard GPS
• UART3, MSP Protocol
• CAN, UAVCAN Protocol
• I2C, onboard QMC5883L & DPS310
• I2C JST-GH connector, external AirSpeed sensor

• CAN bootloader LED, Blue
  • Fast blinking,  Booting
  • Slow blinking, working
• GPS PPS LED, Green
  • blinking(1Hz) when GPS has 3D fixed
• Boot button

• Input voltage range: 4.5~5.5V (5V pad/pin)
• Power consumption: 100mA
• Operating Temperatures: -20~80 °C

• 29mm*29mm*9.7mm
• 11.3g

Includes

• 1x M8Q-CAN
• 2x JST-GH-4P to JST-GH-4P 20cm silicon wire

Tips

• u-blox M8Q series has no external flash memory
• Compass Alignment(Arrow forward and flat mounting):
  Ardupilot/Mission Planner: Rotation None
• Make sure to have compass/magnetometer 10cm away from power lines/ESC/motors/iron based material
• The scratches on ceramic antenna are the result of tuning the antenna by ublox.
• HD cameras(Gopro, Split, Tarsier, etc) could interfere GPS signal, try turning off HD camera before GPS 3D fix
• Blue LED status can’t show communicating between CAN node and Flight Controllers since MSP was supported.

More Details : http://www.mateksys.com/?portfolio=m8q-can#tab-id-1