ORIGINAL Matek HUBOSD Eco H-Type with PDB

HUBOSD8 has been engineered to provide the highest possible performance and reliability in a 46*36mm & 4 layers PCB. It is a multifunctional HUB with PDB, BEC 5V/2A &12V/500mA, Current sensor 140A, STOSD8. It is specially made for the mini FPV Quad. The BEC 12V is linear regulator, no LC Filter needed. Built-in STOSD8 can support Plug & Play, no complicated settings needed.

Specifications:

Input: 8~ 21V (3-5S LiPo) PDB: 4x30A (Max.4x35A) Regulated 5V and 12V outputs Current Sensor 140A Built-in STOSD8

Physical: - 2oz copper, 4-layers &1.6mm PCB. - 1x Battery input, 4x ESC outputs. 2x BEC 5V outputs, 2x BEC 12V outputs. - Camera signal & Gnd pads, Video Transmitter Signal & Gnd pads - 1x Serial port (RX, TX, G) - Dimensions: 46x36x4mm, Weight: 8.5g - Mounting holes 30.5mm square spacing,Φ3mm

PDB (ESC outputs) Continuous current: 30A per output Peak current (10 seconds/minute): 35A per output

BEC 5V outputs Designed for RC Receivers, Flight controllers, OSD, and Servos. DC/DC synchronous buck regulator. Voltage: 5.0 +/- 0.1VDC Continuous current: 2 Amps (Max.2.5A 10s/minute) Output Ripple: 40mV (VIn=16V, VOut=5V@2A load) Short-circuit tolerant (5 seconds/minute)

BEC 12V outputs Linear regulator, very low noise. LC Filter is needless. Designed for Video TX or FPV camera. Voltage: 12.0 +/- 0.3VDC (4~5S operation) Continuous current: 500mA@16V IN, 400mA@20V IN Short-circuit tolerant (2 seconds/minute) If the battery is 3S LiPo, Output voltage=3S LiPo voltage - 1V