HOBBYWING XROTOR 4IN1 ESC FOR FPV RACING - MICRO 60A BLHELI32 DSHOT1200 (3-6S)

If you never want to worry about your your 4-in-1 again, Hobbywing's XRotor 60A  raises the bar once again! From Captain Vanover himself, this thing is "bullet proof". No matter what type of flight style you choose, this should be a go-to 4-in-1 for everyone! The soft mounts prevent most of the vibration from being transferred to the FC. From freestyle to racing, even long range will not challenge this ESC. The 60A Micro 4-in-1 ESC comes loaded with the latest 32bit tech, as well as BLHeli32 firmware, DShot1200, Larger FETs, direct pins for a capacitor, and a choice of either a plug n play ESC connector or solder pads for the flight controller.

XT60 pigtail and Cap are solderd on from maufacturer.

Check out all our Electronics Speed Controllers and the rest of our HobbyWing Products!

 FEATURES:

• High-performance 32-bit microprocessor with the running frequency of up to 48MHz for an excellent performance.
• BLHeli_32 firmware is the third generation BLHeli, following base BLHeli and BLHeli-S.
• All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling.
• The code supports features to prevent sync loss. There are tunable parameters that can make the code run well even in the most demanding situations, although default settings will work excellently in normal operating environments.
• The code supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us) and Multishot (5-25us).
• Dshot signaling is supported at any rate up to at least Dshot1200. The input signal is automatically detected by the ESC upon power up.
• The code also supports a beacon functionality, where the ESC will start beeping after a given time of zero throttles. This can be very useful for finding lost crafts.
• Onboard 5V BEC, powering different accessories such as FC, VTX, Camera and LED lights and etc.

SPECIFICATIONS:

• LiPo Power input: 3S-6S
• Cont.Current: 60Ax4
• Burst Current: 80Ax4
• BEC Output: 5V@ 1.5A 
• Input wires: 12AWG-130mm* (Red/Black)
• Output Wire: No wires but solder tabs
• Connectors: (In/Out) XT60 (w/ Wires Soldered on) /no
• Weight / Size: 15.0g / 32.7x18.4x6.2mm
• Mounting holes: 30.5x30.5mm
• Throttle Calibration: Supported
• ESC Programming: BLHeliSuite32

PACKAGE INCLUDES:

• 1x XRotor 60A 4-in-1 ESC