ETHIX MR STEELE STOUT MOTOR V4 (TUMBLED EDITION)

The wait is over!

I would like to Introduce the Mr. Steele V4 STOUT 2306 (1750KV) 6S FPV freestyle motor. 

I take great pride in my work and am always trying to raise the bar. After two years of seemingly nonstop research & development, I am proud to present this fine piece of Miniquad motor engineering. 

V4 MOTOR HIGHLIGHTS/CHANGES 

• base redesign 16x16(only) mounting holes (structural changes for more durability)
• Complete bell redesigned (durability and smoothness in mind)
• Thicker single strand copper winding 
• increased EFFICIENCY & POWER 
• Complete Interchangeable motor pants redesign (thicker & more crash/low temperature resistant, better gap fitment, + more protection coverage for the “tall pants”)
• better assembly tolerances 
• Overall QC improvements
• 9mm steel bearings  
• Eco-Friendly packaging 
• Motor weight 31.8g 
• (full-length cables) compared to Stout V3 at 30.5g 

PANTS WEIGHTS 

• Low - 1g vs (0.8 v3)
• Tall - 2g vs (1.8 v3)

All in all this motor is an absolute gem only increasing the weight by a tad over 1g from the previous model while achieving more power, efficiency, and most importantly durability. 

V3- V4 COMPATIBILITY 

• V4 and V3 motors are completely cross-compatible. 
• V3 bells - V4 stator 
• V4 bells - V3 stator 

( everything is interchangeable except pants) The pants are stator-specific and can be interchangeable but with less than desired effect. 

 Enjoy & Thank you for your continued support.

-Steele

SPECIFICATIONS

INCLUDES

• 1 x Motor
• 1 x Tall Motor Pants
• 1 x Short Motor Pants
• 4 x motor screws