IB-Prostart RC Engine Heater
short desc
₹5,342.40
Availability:
In stock
In stock
SKU
364
Nitro Engine Pre Heater.
Fits all 21/28 nitro engines. The heater can be powered using a car battery or starter box’s own 12v gel cell battery supply or separate 11.1V 3S LiPo or a Balance Charger.
The heater makes engine starting a breeze and strongly recommended for engine break-in. Works especially good at tracks where engine idling is not permitted before you race. Heats engine head to 200' F within 5-15 minutes depending on ambient temperature.
Additional Features:
Pre-heats all critical engine parts for easy starting
Saves money on expensive Nitro Fuel use during warm-up
Removes stress from connecting rod during starting
Allows faster engine tuning since engine is already up to operating temp upon start up
May increase engine life expectancy by up to 100%
Small and lightweight for easy storage
Directions:
Place the heater over the engine cooling head and keep the wire facing the rear wing
Plug the connector to 12 volts of power (11.1v 3S LiPo battery or other 12V power source.
Pre heat cycle is from 5-15 minutes based on the ambient temperature
Disconnect the power when pre heat is finished
Carefully remove the heater
Put heater it in a safe place
Cautions:
Make sure to disconnect before removing the heater
Never refuel your vehicle while using the heater
Do not touch the element after using (Extremely hot), it will cause burns.
Make sure to unplug the heater when not in use and keep in a safe place after using
People less than 15 years old should be supervised by an adult when using the heater
The heater comes with a male deans connector to connect a lipo battery as these are the most common type.
Please let us know what colour you prefer and we will do my best to get that one to you.
Embroidery Names and Colors:
IB-Prostart (Blue, Orange, Black)
JQ (Black)
REDS (Black)
Balance Charger Setting:
NiCd
NiMh
2.8 Amps (Max.)
11.5v (Max.)
NOTE: Do not use any other setting other than the settings mentioned above.
LINK TO HEATER REVIEW:
http://www.maxbashing.com/mbforum/showthread.php?33593-IB-Prostart-engine-heater-review&p=210001#post210001
We will not take responsibility of any damage or injury during use or storage of this heater. User is solely responsible for the safe use of this product.