FPVCYCLE 2203 3000KV

FPVCYCLE 2203 3000KV

FPVCYCLE 1303 5000KV - 2MM PROP SHAFT

FPVCYCLE 1303 5000KV - 2MM PROP SHAFT

FPVCYCLE 2203 3450KV

This motor is the next step in its class and is designed to deliver optimal performance for very high load 3”/CineWhoop through 4” and light load 5”.

₹2,957.09

* Price is inclusive of 18% GST

Availability: Out of stock
Out of stock
SKU
Y4143

This motor is the next step in its class and is designed to deliver optimal performance for very high load 3”/CineWhoop through 4” and light load 5”.  It has been built to the highest meaningful specification available today as of the pandemic of 2020 and is unique in the industry.  The Kv has been selected for 3S-4S operation with throttle cuts as the user desires.

THIS MOTOR IS SPECIFICALLY DESIGNED FOR THE FOLLOWING USES:

  • 3” ducted whoop
  • 4” anything
  • 5” light blade and low general AUW for 5”

MATCHING PRODUCTS:

  • CineSplore w/ Gemfan 75mm CineWhoop prop
  • PowerPick 4” with Gemfan 4023 prop
  • PowerPick 5” with Gemfan 5125 prop
  • Fouride 4” with Gemfan 4023 prop
  • Fouride 5” with Gemfan 5125 prop
  • Red T-mount props are fantastic with Gemfan 4024
  • 3000kv version is suitable for CineWhoop/CineSplore on 6S if desired

RECOMMENDED BATTERY OPTIONS:

  • 3S 1000-1500mah on 3450kv with CineWhoop 3”, 4”
  • 4S 1100-1300mah on 3450kv with CineWhoop 3” or 4”
  • 4S 1100-1300mah on 3000kv with CineWhoop 3”, 4” or 5”
  • 5S 1100-1300mah on 3000kv with CineWhoop 3” or 4”
  • 6S 850-1000mah on 3000kv with CineWhoop 3” (6s for any cinewhoop is not recommended)

You’re welcome to run full 4S with no throttle cut on 3450kv and 5” but be warned that it will be extremely overpowered on a very light platform and a challenge to tune.  Not PID tuning, general tuning of everything but PID’s.  With this very high power, if your filters and overall electronic management is not done right, the motors have some minor risk of burning.  We’ve over stressed them quite a bit with no issues but the motors did get extremely hot.  Even though these motors have super high temperature enamel coating on the winds, we are not responsible for burnt motors due to misuse.

SPECIFICATIONS:

  • 22mm stater diameter, 3mm stater height
  • 12x12mm M2 mounting pattern (not flush mount)
  • ~20g with ~150mm length wires
  • ~17g with short cut wires (T-mount red version is 0.55g lighter)
  • 0.15mm Kawasaki High performance laminations
  • N52SH ARC magnets
  • 3mm grade 5 titanium internal shaft C clip retention (much lower weight)|
  • M5 grade 5 titanium prop shaft
  • 3x8x4mm 693zz Japan ISC Custom bearings
  • 7075-T6 aluminum casing
  • 260℃ enamel coated single wrap oxygen-free copper windings
  • Bearing saver damping washer under bell/on top of bearing
  • Tuned steel flux ring