Eachine TX805 5.8G 40CH 25/200/600/800mW FPV Transmitter TX LED Display Support OSD/Pitmode/Smart Audio - SMA Female

1. Pitmode

2. Support Smart audio

3. 40 channels with MIC

4. Power failure memory

5. 25/200/600/800mw power switchable
6. Support OSD Configuring via Betaflight FC
7. One button frequency and power setup

8. 7-24V wide input voltage with 5V for camera,12V typical corresponding current value:

    25mw-120mA 200mw-200mA 600mw-300mA 800mw-350mA
9. Solid MMCX antenna connection and MMCX brass dipole antenna 
 

Select channels by simple short presses.

Blue LED light on stands for CH1,short presses to change 8 channels sequentially.

For CH2/3/4/5/6/7/8,Blue LED flicker once,it won't light on.

Notice:Blue LED only light on for CH1

Press button for 2S,Red LED will flash,then short presses to select 5 bands.

Press button for 4S,Red LED will flash,then select power by simple short presses to select 25mW/200mW/600mW sequentially,For 200mW, Green LED flicker once,it won't light on;For 600mW Blue LED flicker once,it won't light on .Press the button again ,Red LED,Green LED and Blue LED lights together,Represents the highest power 800mW.

Notice:Red LED only light on for 25mW.

While in Pit Mode you can change channels and set power levels , but none of these changes will take effect until you quit Pit Mode.By default ,Pit Mode will send a very weak signal.

Two ways to exit pit mode:

Press button 12S until all 16 LED turned off and light on again to exit pit mode,or you can exit pit mode via Betaflight OSD.

Notice:The VTX has memory for settings,To change the settings ,please repeat steps as above.

Package included:
1 x Eachine TX805 5.8G 40CH 25/200/600/800mW FPV Transmitter VTX 
1 x Adapter connector cable (RP-SMA or SMA Female)
1 x MMCX Pigtail Antenna

1 x Instructions