Pixhack V3

 

The CUAV Pixhack V3 flight controller board is a flexible autopilot intended primarily for manufacturers of commercial systems.

 

The board is a variant of the SOLO Pixhawk® 2 (PH2) flight controller, which is in turn based on the Pixhawk-project FMUv3 open hardware design. It runs PX4 on the NuttX OS, and is fully compatible with both PX4 or ArduPilot® (APM) firmware.

 

Pixhack V3 has significant improvements with respect to the original design, including better interface layout and the addition of vibration damping and a thermostat system.

 

 

Specs

 

• Microprocessor:
  • STM32F427
  • STM32F100 (Failsafe co-processor)
• Sensors:
  • Accelerometers (3): LS303D, MPU6000, MPU9250/hmc5983
  • Gyroscopes (3): L3GD20, MPU6000, MPU9250
  • Compass (2): LS303D, MPU9250
  • Barometer (2): MS5611 X2
• Interfaces:
  • MAVLink UART (2)
  • GPS UART (2)
  • DEBUG UART (1)
  • RC IN (for PPM, SBUS, DSM/DSM2)
  • RSSI IN: PWM OR 3.3ADC
  • I2C (2)
  • CAN BUS (1)
  • ADC IN: 3.3V X1 , 6.6V X1
  • PWM OUT: 8 PWM IO + 4 IO
• Power System:
  • PM POWER IN: 4.5 ~ 5.5 V
  • USB POWER IN: 5.0 V +- 0.25v
• Weight and Dimensions:Other Characteristics:
  • Weight: 63g
  • Width: 68mm
  • Thickness: 17mm
  • Length: 44mm
• Operating temperature: -20 ~ 60°C

 

Package Includes : -

•  Pixhack V3 x1
•  Vibration damper plate x1
•  8gb micro sd card x1
•  USB cable x1
•  8CH PPM encoder x1
•  Voltage and current sensor x1
•  I2C extension board X1
•  Buzzer with safety switch x1
•  PW WIFI Link (without case ) x1
•  Cable x2